* Models can also be re-used for similar looking faces for more rapid training.Starting a new model: Make sure that you have copied a fresh version of C:\FakeApp\model into C:\fakes\model. Otherwise, you will train on top of an existing deep learning model that incorporates features of other faces.Saving a model: If you have previously run the FakeApp and would like to save the existing model, copy the entire contents of the C:\fakes\model directory into another location.Loading a model: If you have previously saved a model, you can copy it into C:\fakes\model for further training. You can also use models that you may have downloaded from elsewhere.Begin training: Once your model folder is setup correctly, and all of your aligned images are cleaned and ready, click the Train tab.
Be sure to enter the correct paths with forward slashes and a slash at the end, as shown here.
IMPORTANT: Even if the defaults look correct, you must click on each box and re-type the path. Again, if there are default values, make sure to re-type the complete path, and add the slash at the end. Otherwise, you may get an error as the defaults are not loaded properly.
Close all other programs & click Start. optimize settings if you run out of memoryOnce you see faces, leave it for ~2 hours!! Lunch
Check list of values. Should be 0.02 or less.Press q to stop training.You can change the training images (make sure to re-extract and clean the training set properly) and continue the training later if you desire as long as you save the model files. Be sure to use the same layers and nodes parameters if you decide to train again later